As previously announced in my intro presentation:
[ https:// www.growroom420.com/vaporist-of-borg-4466 ]
GR420: Vaporist of Borg. (2019-Nov-23)
This present proposal is intended to illustrate semi-DiY enhancements of an existing product invented by Dan Steinberg and for which a patent was actually registered just a couple years after Y2K. It's his materials selection which captured my attention, though my own initial series of experimentations didn't address the Fig. 11/12 element until mid-2015 as i vaguely recall.
Anyway, before i describe my current configuration lets consider our primary objective:
M'well, through a microscope as this happens to be where the real fun resides:
Trichomes! That's a most precious gift of dame Nature as each of these shiny spheres conveniently collect noble substances away from vegetal tissue on a molecular basis - which proves being synonymous to high quality filtration performed at the most efficient cost imaginable - and there's more!...
Looking at the whole collection of features size/mass emerge as a hint about how to perform discriminative extraction, by virtue of simple physics:
It appears to suggest a consumption method based on "Pulse Heating" where an early bake-less "Release" phase 1st targets tiny objects based on their contact-surfaces. Lucky me my customized pipe could be fine-tuned enough to provide a useful approximation sufficiently convincing to validate such strategy, hence no absolute phase separation is required considering a bowl is "done" after 5 ~ 6 tokes in any case. On another hand my "Micro-Bursting" scenario depends on "bio" that wasn't industrially processed as this defeats its operating principles:
TUMBLED WEED!!

So here's how to proceed in order to access such pulse-mode extraction as promised, in order of priority:
Modification of the "Monobloc" allows implementation of some On-Top Core-PinHole features, possibly with provisions for handle-side manual control. For example:
Then reconfigure this top's internal layout around an hybrid Core as this makes possible to reduce distance to the bowl. These next few snapshots should help envision restricted injection of fresh-air directly above its "workload" to cause a radical translation of dynamics, hence resulting in much easier/less critical operation:
As for manual control its not essential although quite pleasant to have:
And finally i'd favour eye-contact on a flame's tip as well:
Now here's some approximative schematic to conclude on the basic "PinHole" and "Hybrid Core" aspects:
It's a temporary thermal bottle acting similarily to a slingshot where the rate of energy build-up is partly separate from its release which is practically instantaneous as a result of dimensions, effectively realizing a Pulse Heating conversion of the venerable VaporGenie pipe.

Good day, have fun!!