Show my Grow & Advice

[SmokeyJoe]

Im gonna give em both 2L of straight water today, ill PH it but cant change it till i get some solution.

See if i get any run off at 2L.

Quick Question, when i do get run off, do i need to remove it, assuming i do, pretty sure ive read somewhere it needs removing.

Thanks again.

[kbag]

Yes you need to remove run off straight away if they are standing in them tray's.
A cheap solution and great for collecting plant run is paint roller trays. i think GMO got his from poundland.

[kbag]

I also think the floor fan would be a little to much for them atm what can cause wind burn. Try facing it at wall of the tent or away from the plants. Also the ducting going into the sock at the bottom of the tent is for your Carbon filter?

[SmokeyJoe]

Hi.

No the bottom is inflow of air with a fan pushing air in.
Sorry to be clear, the lower back 6" Duct is outflow from Carb Filter
The 4" Duct at the lower front in the intake.

The carbon is at top of tent removing air.

I have negative pull when the tent is closed.

I'll move the fan as you suggest.

Thanks.

Sent from my SM-G955F using Tapatalk

[SmokeyJoe]

Fan Moved & some more pics





SJ

[SmokeyJoe]

They have both had 2L of Tap Water now and this indeed ran through so i go rid of the excess.

Ill check on them tomorrow and see how they are getting on.

Thanks again people.

[SmokeyJoe]

Smokey which country are you from mate?

I is in the United Kingdom, you?

[SmokeyJoe]

I am in the UK too, but I am not from the UK.

Well half of me is.

The bottom half lol

[GMO]

I'm just gonna throw my 2 cents in too mate, looks like you have the start of some light stress going on. I'd raise your light just 4-6 inches and wait for the serrated part of the leaf to lay flat before increasing light any more

Good luck tho mate

Sent from my SM-G950F using Tapatalk

[SmokeyJoe]

I'm just gonna throw my 2 cents in too mate, looks like you have the start of some light stress going on. I'd raise your light just 4-6 inches and wait for the serrated part of the leaf to lay flat before increasing light any more

Good luck tho mate

Sent from my SM-G950F using Tapatalk

Hi GMO. Cheers for the comments. I've not mentioned that I was using a HPS 600W bulb without any heat filters on it. Just a straight reflective hood.

I researched and chose the Migro 200 setup. Had great reviews. They have been on this light only a few days. The back one perked up pretty quick after changing lights. It was quite droopy before.

So ya think I should lift lights to about 20 inches from top of plants. I have trying to read up on LS and the methods. Makes me nervous and don't want to damage them.

Im not sure now how much nutes to use going forward as this thread seems to point to the fact I've over nuted them.

SJ.

Sent from my SM-G955F using Tapatalk