New setup tips and tricks RDWC

[Back Room Farmer]

Also doing all air hoses and feed hoses in black return pipes are orange but I don't see light getting through them.

[Nanook]

subbed, I will take a look and reply later :)

[Back Room Farmer]

Whish one is best?

[Back Room Farmer]

the chiller I am looking at can handle 180 liters an hour so about 54 gal an hour if I run return bucket to pump to outflow bucket through chiller to pots in an 18 gal system thats 3 full changes cycles an hour. is that enough?

Everything I read says 7 times an hour. So how about return and last bucket just chiller out and back into same bucket second "end" bucket pump out to circuit?

[Back Room Farmer]

Might do waterfall system. Seems the chiller would be more effective.

[Back Room Farmer]

https://www.youtube.com/watch?v=aPWN5atC0BY

Like this but with round buckets. You think 2" is still ok?

[MrMan]

i built a waterwall rdwc system a while ago using buckets
i did make some changes that were not in the guide
1. i changed the bottom return pipes from 19mm to 25mm iceline (only reason for iceline was i couldnt find standard 25mm at a decent price
2. switched to a larger airpump and waterpump mainly because i could
3. changed the bulkheads on the bottom from uniseal to standard plaastic when i changed to 25mm iceline main reason i changed from uniseal was i couldnt get an acurate od measurement of the pipe
viewtopic.php?f=10&t=232&hilit=waterfallthats

[Trex]

https://www.youtube.com/watch?v=aPWN5atC0BY

Like this but with round buckets. You think 2" is still ok?

You will have a hard time sealing a round bucket to a 2" bulkhead fitting . unless u do some mighty fuckeroo ,
You can get some that a prefitted for round cisterns but cost a fortune to say the least . youre best off with square buckets pal , trust me im a plumber lol its doable but get ready for swearing


Grapefruit Banner Pheno Finder Journal

https://r.tapatalk.com/shareLink/topic? ... source=app

[Nanook]

yeah I would go for square/rectangular tubs tbh.

[Norseman]

This guy does make some really nice stuff.

[youtube]www.youtube.com/watch?v=aPWN5atC0BY&t=8 ... ydroponics[/youtube]

This YouTube linking doesn't fucking work at all.... @Minty