Diy halo rings

[Josh]

I've been using these for nearly 4 weeks now and their working lovely mate

Sweet you end up doing anything differently? I found that I needed a lot more water pressure than I originally thought for the rings to function properly

Sent from my LGMP260 using Tapatalk

[Nom]

Instead of the screws for legs i used some wooden skewers from the kitchen draw, shortened them and staked them into the pot apart from that its the same mate. I started with a 1000 lph pump which was noisy as hell, then tried a 500 lph pump and it still comes out at a good rate so stuck with that for now. I really should measure the flow rate properly, but I've just been leaving the timer on for 15 minutes and I'm getting a good run off

[Josh]

Instead of the screws for legs i used some wooden skewers from the kitchen draw, shortened them and staked them into the pot apart from that its the same mate. I started with a 1000 lph pump which was noisy as hell, then tried a 500 lph pump and it still comes out at a good rate so stuck with that for now. I really should measure the flow rate properly, but I've just been leaving the timer on for 15 minutes and I'm getting a good run off

Awesome, good stuff Nomoli

Sent from my LGMP260 using Tapatalk

[Josh]

To the Video app.php/vblog/josh/25/241
To the Video app.php/vblog/josh/25/242

just re-posting the vid links, I noticed the original ones were no longer working anybody know why videos load so slow on the site? I might start storing my diy vids on the gr420 youtube instead